- Remove all the grips and pull rods.
  - Move the crosshead up so that it is fully out of the chamber
  - Reset the gauge length.
  - Place the position limits so that the crosshead cannot come down on the chamber while it is being moved.
  -  Unscrew the two bolts located at the bottom sides of the chamber
  - Slide the chamber into its non-use position. Make sure it is secure in this position.
  - Put the top pull rod back if needed.
  - Reset the position limits so that, in this new setup, the grips cannot touch each other or damage the chamber ceiling.
  - Bring the top fixture back down and reinsert the grips.
  - Put the lower pull rod and grip back.
  - Reset the gauge length and balance the load.